SP Building Systems offer a wide range of cee and zee sections for use in light framing applications or to replace hot rolled sections. Sizes range from 4 1/2 to 16 inches wide with leg lengths from 2 to 3 1/2 inches with an infinite choice of sizes in between and in gauge that range from 16 gauge to 3/16 inches thick. These steel structural sections are a great choice and very affordable.
Roll forming is done on a Metform roll former that is unique in Canada. Instead of the normal 4 to 5 hour changeover required by traditional roll forming equipment, SP Building Systems can change from cees to zees or various widths or leg lengths in 5 to 10 minutes. Therefore it is possible to make small runs of a few hundred feet without expensive setup times.
A wide range of inline hole patterns allow the creation of a section to your specifications, cut to your required length with holes and no waste.
Roll forming is done on a Metform roll former that is unique in Canada. Instead of the normal 4 to 5 hour changeover required by traditional roll forming equipment, SP Building Systems can change from cees to zees or various widths or leg lengths in 5 to 10 minutes. Therefore it is possible to make small runs of a few hundred feet without expensive setup times.
A wide range of inline hole patterns allow the creation of a section to your specifications, cut to your required length with holes and no waste.
Features of SP Building Systems's Roll Formed Sections
No minimum order required
No setup charge
A wide range of standard hole patterns
Lengths to suit your requirments
No material waste
Painted if required
Fast delivery of sections cut from stock coil
Many sizes of coil in stock
No minimum order required
No setup charge
A wide range of standard hole patterns
Lengths to suit your requirments
No material waste
Painted if required
Fast delivery of sections cut from stock coil
Many sizes of coil in stock
Material Designations
Any material, including hot rolled, P&O, galvanized, pre-painted steel or aluminum, with a yield of 30,000 to 70,000 PSI can be used, but the most typical is hot rolled steel with a 50-55 yield. Special material are subject to availability.
Painting
An optional coat of light grey hybrid powder paint (epoxy/polyester) can be applied with an inline powder paint system. Maximum length of part is 42 feet when powder paint is used. Other types of powders and colours are available and may be subject to minimum order sizes.
t
Any material, including hot rolled, P&O, galvanized, pre-painted steel or aluminum, with a yield of 30,000 to 70,000 PSI can be used, but the most typical is hot rolled steel with a 50-55 yield. Special material are subject to availability.
Painting
An optional coat of light grey hybrid powder paint (epoxy/polyester) can be applied with an inline powder paint system. Maximum length of part is 42 feet when powder paint is used. Other types of powders and colours are available and may be subject to minimum order sizes.
t
To get more information from our specialists, contact SP Building Systems
